MapWindow 4 - ActiveX Control Programming : MapWindow Discussion Forum
Hey guys, I have a quick question. As you might have guessed by now, I'm trying to load a Esri Grid into an Axmap. I've gotten to the point where the program is pointed in the right directory but when I try to add a new layer with the grid file it comes up with an error stating that the interface i
loading a GRID file into Axmap
Posted by:
radioheadCDA ()
Date: February 28, 2011 09:45AM
Hey guys, I have a quick question. As you might have guessed by now, I'm trying to load a Esri Grid into an Axmap. I've gotten to the point where the program is pointed in the right directory but when I try to add a new layer with the grid file it comes up with an error stating that the interface is not supported. I was sure that Axmap had the capability of loading an Esri Grid so that's why I'm here. Is there anything different that needs to be done in order to add a Esri Grid layer into an Axmap or is it just not possible? Any advice would be greatly appreciated. Thanks very much!
Re: loading a GRID file into Axmap
Posted by:
sindizzy ()
Date: February 28, 2011 08:04PM
Have you tried to load it with the MW application?
AGP
AGP
Re: loading a GRID file into Axmap
Posted by:
radioheadCDA ()
Date: March 01, 2011 08:31AM
I haven't tried that. What would that tell me if it did?
Re: loading a GRID file into Axmap
Posted by:
sindizzy ()
Date: March 01, 2011 10:54AM
Same thing as when you load a shapefile...you will see it on the map. If not there should be an error message.
AGP
AGP
Sorry, only registered users may post in this forum.
